crwdns2933803:010crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Building Fysetc Spider Firmware 3 | |
| [* black] Run the following: | |
| [* black] make | |
| [* black] make flash FLASH_DEVICE=####:#### | |
| [* black] Using the ID you notated earlier in place of ####:#### | |
| [* black] Remove the jumper and press the reset button on the board. | |
| + | [* black] Run the following |
| + | [* black] ls /dev/serial/by-id/* |
| + | [* icon_note] This is the ID you will put in printer.cfg |