crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:010crwdne2933803:0

crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Building Fysetc Spider Firmware 3
[* black] Run the following:
[* black] make
- [* black] Using a program like WinSCP or CyberDuck, navigate to \home\pi\klipper\out
-[* black] Copy klipper.bin to your PC. Make sure you rename it to firmware.bin.
-[* black] You will need a SD card formatted as FAT32. It cannot be EXFAT.
-[* black] Copy firmware.bin to the SD card.
-[* black] Power off the Pi and the Spider.
-[* black] Insert the micro SD card into the Spider and power on the board.
+ [* black] make flash FLASH_DEVICE=####:####
+ [* black] Using the ID you notated earlier in place of ####:####
+[* black] Remove the jumper and press the reset button on the board.
+[* black] Run the following
+ [* black] ls /dev/serial/by-id/*
+ [* icon_note] This is the ID you will put in printer.cfg