crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Ryn Scrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Repair Skeleton

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[title] Step 7 Removing the trigger caps
-[* black] Next we are gonna need to remove the trigger caps, for the next screws in this manual we need the torix 6 screw bit.
- [* black] Unscrew the little screw on the backsides of the caps and just gently push the platic around the trigger from the outside towards the inside
-[* icon_note] Inside you see a little grey motor, this is your rumble motor, please always try to limit the strain on the cable . ( don't let them hang when picking up)
+[title] Removing the trigger caps
+[* black] Next we are going to remove the trigger caps. Use a T6 bit for this.
+ [* black] Remove the screws on the backsides of the caps and just gently push the plastic around the trigger from the outside towards the inside
+[* icon_note] Be careful of the small gray rumble motors. Try not to let them dangle by their wires while working.