crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:011crwdne2933803:0

crwdns2933797:0Ze Amayacrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ze Amaya

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Using air blowing to clean CMOS is very simple. First pick up the air blow and pinch it twice, then let the camera CMOS rush down, then let the air blow nozzle aim at the CMOS and pinch it a few times. It is not recommended that the air blowing nozzle go deep into the interior of the camera, mainly for fear of accidentally poking some parts.
-[* black] If the CMOS is accidentally stuck with grease and water stains, it must be cleaned by "wiping". Before wiping, blow twice with air to remove the dust particles on the surface to avoid scratching the protective mirror on the CMOS surface during wiping.
+[* black] Use the “air blow” tool to remove particles from the camera sensor. Do not allow the camera to enter too deep inside the camera. This is to avoid any damage.
+[* black] For tougher stains on the sensor, blow air on the stain to remove any particles. Then, clean the stains with an alcohol wipe.