crwdns2933803:04crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Preparing printer.cfg |
|---|---|
| [* black] Uncomment the input shaper & resonance tester section in the config. | |
| [* black] probe_points: It's recommended to use 1 point in the center of the bed slightly above. I used the same coordinates used when homing Z | |
| [* black] Restart klipper with | |
| [* black] RESTART |