crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Joe Fraziercrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* blue] While firmly holding the logic board, use a metal spudger to unclip the four clips holding the screen on.
- [* icon_note] The clips will not be reusable once removed.
- [* black] Now gently pull the screen slightly away from the logic board so that none of the clips are engaged on the board.
-[* black] Last, use the metal spudger to push back the ribbon cable lock. Pushing back and up on the cable lock will release the cable.
+[* black] Detach the screen from the logic board by using a metal spudger to unclip the four clips holding the screen. Gently pull the screen away from the logic board so that none of the clips are engaged.
+ [* icon_note] The clips may weaken and break after unclipping them.
+[* black] Remove the screen completely from the logic board by using a metal spudger to push back and up on the ribbon cable lock to release it.
+[* black] Install the new screen by following these steps in reverse order.