crwdns2933803:02crwdne2933803:0
crwdns2933797:0ONI_ICHIcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 ONI_ICHI
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove PCB and rail screws |
|---|---|
| + | [* black] Remove the single screw holding in the PCB. |
| + | [* black] Unplug the three pins connected to the board (the one on the left is the potentiometer, and the two on the bottom are the foot pedals). |
| + | [* black] Carefully lift the external cable up from the cradle. You will now be able to remove the PCB. Set the PCB and the main cable aside in a safe place. |
| + | [* black] Remove the screws holding the foot rests to the rail on the bottom. There are six per foot rest. |
| + | [* black] Under each pair of screws is a piece of plastic that you can also remove. Set these aside. |
| + | [* black] If the two middle screws are obscured, just slide the foot rest up or down to get access to the screws. |
| + | [* black] It may not be necessarry but I also removed the two screws at the bottom of the foot rests, just below the last set of screws. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0