crwdns2933803:011crwdne2933803:0
crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Test and calibrate a new Instant Pot sensor |
|---|---|
| + | [* icon_note] The next two steps will give you general guidance on how to test and calibrate a new ***high pressure*** sensor. Depending on your replacement part and Instant Pot model, this may not work for you. |
| + | [* black] Install your replacement pressure sensor and reassemble the Instant Pot. |
| + | [* black] Add 3 cups of water to the Instant Pot and set it to cook on high pressure for five minutes. |
| + | [* icon_caution] If the emergency vent begins to leak or vent during the heating cycle, the pot is over-pressurizing. ***Immediately unplug the Instant Pot and perform a quick release. *** |
| + | [* black] Once the five minutes are up, vent using quick release. |
| + | [* icon_note] There should be a strong pressure release. If there isn't, the Instant Pot is not reaching sufficient pressure. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0