crwdns2933803:01crwdne2933803:0
crwdns2933797:0Flavien Driardcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Flavien Driard
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] diagnostic |
|---|---|
| + | [* black] If the Z-axis is no longer working. |
| + | [* black] disconnect the power cable to the printer and open the bottom and on the mother board switch the cable to Z-step motor with the one to the extruder step-motor. |
| + | [* black] close the bottom and start the printer in setting mode. |
| + | [* black] request the extruder to move forward a little, and if the Z-motor move, you can confirm the Z-motor is working as expected. |
| + | [* black] You can order a new driver online. |
| + | [* black] I choose a DM556, because it is cheaper than the DM542. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0