crwdns2933803:03crwdne2933803:0
crwdns2933797:0BoulderMakercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 BoulderMaker
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the Plastic/Rubber Foot |
|---|---|
| + | [* black] There's a recycled plastic and rubber foot affixed to the bottom of the device. This acts as a higher-friction softer foot so as not to scratch surfaces, like wood, and to dampen vibrations. It also covers the re-flash port. This footing is held on by a light seam of adhesive that is easily compromised. |
| + | [* black] Using a controlled heat source, warm the foot to loosen the adhesive. |
| + | [* black] Insert a pick between the foot and device body to pry them apart. If warmed adequately, the foot should be easy to pop off. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0