crwdns2933803:01crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Wiring |
|---|---|
| + | [* black] You will be removing the yellow and green wires from terminal 1 and 2 from [guide|143985|step 2|stepid=291527] |
| + | [* black] Re-crimp the wires and using a 3 pin connector connect it to E1_STOP on the Duet |
| + | [* icon_note] Polarity of the green and yellow wire doesn't matter. |
| + | [* black] Add the commands for "output_pin psupower" "gcode_macro M80" "gcode_macro M81" and "gcode_button power_on" to your printer.cfg |
| + | [* black] I've uploaded my config to my [link|https://github.com/armysolo/BLV-Cube/tree/main/Firmware/Klipper%202x%20Independent%20Z%20Fysetc%20Cube%20Duet%202%20Wifi|github] |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0