crwdns2936039:0Power Mac G4 Quicksilver Teardowncrwdnd2936039:014crwdne2936039:0

crwdns2933803:014crwdne2933803:0

crwdns2933797:0Adam O'Cambcrwdnd2933797:0Ndz 6, 2018crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb

	[title] Logic Board
	[* black] Start by disconnecting everything, cables, battery, etc.
	[* red] There are three hex-shaped screws holding the board, which are right where the CPU was. These also provide the screw holes to screw and hold the CPU. Use an English 1/4" size socket to remove these three screws left behind from the CPU.
	[* icon_note] I used a metric size socket(I believe it was 7mm), as I did not have an English size handy, and the metric seemed to work fine.
	[* orange] Then remove the 4 screws which are located around the edge of the board. If you have less than 4 screws, don't worry too much, if you don't have trouble removing the board at the next step, then you are fine.
-	[* icon_caution] REMEMBER TO GROUND YOURSELF! ~~THIS CANNOT BE OVEREMPHASIZED!~~
+	[* icon_caution] REMEMBER TO GROUND YOURSELF! Use an [product\|IF145-071-1\|anti-static wrist strap\|new_window=true] to prevent ESD damage to your logic board.
	[* black] Now, slide the logic board away from the rear of the case about 1/2 inch, and lift it out. It should not be difficult to pull out or up, if it is, go back, and make sure you have removed all screws. I did, however, have to pull out towards the front, then up, then back towards the back of the case before I could completely remove the board.