crwdns2933803:02crwdne2933803:0
crwdns2933797:0Andrew Infantadocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Infantado
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove back cover |
|---|---|
| + | [* black] Using a heated bed (or the iOpener), heat up the device's adhesive for 2 to 3 minutes. |
| + | [* black] If using a heated bed, set the bed temperature to 80-85 degrees Celsius. |
| + | [* black] ''I don't own a heated bed for device repair, however my 3D printer's heated bed worked just fine.'' |