crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:011crwdne2933803:0

crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Lay a hot iOpener along the upper left corner of the iPad, spanning from the opening pick to the front-facing camera.
-[* black] After letting the adhesive soften, insert the blade of your halberd spudger into the iPad above the opening pick.
-[* black] Cut the adhesive along the upper left side of the iPad towards the front-facing camera using the halberd spudger. This may require reheating the edge of the iPad.
+[* black] Lay a hot iOpener along the upper left corner of the iPad, spanning from the opening pick to the front-facing camera. Wait a minute to let the adhesive soften.
+[* black] Use an opening pick to slice the adhesive along the upper left side of the iPad. If the slicing becomes difficult, reheat the edge and try again.
+ [* icon_caution] Be careful not to insert the opening pick deeper than 2 mm as you slice along the left edge.