crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:09crwdne2933803:0

crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Lay a hot iOpener along the bottom left corner of the iPad, spanning from the opening pick to the home button.
-[* black] After letting the adhesive soften, insert an opening pick or halberd spudger into the iPad next to the opening pick.
+[* black] After letting the adhesive soften, insert an opening pick or halberd spudger into the gap next to the Smart Connector.
[* icon_caution] Be careful not to insert the opening pick deeper than 2 mm.
-[* black] Slice the adhesive along the bottom left side of the iPad using the opening pick. If the slicing becomes difficult, reheat the edge and try again.
+[* black] Use an opening pick to slice the adhesive along the bottom left side of the iPad. If the slicing becomes difficult, reheat the edge and try again.