crwdns2933803:08crwdne2933803:0
crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] While holding down the corners of the device, repeatedly pull up on the display then ease it back down to weaken the adhesive. |
|---|---|
| + | [* black] Once you've opened a small gap between the front panel and the rear case, insert the blade of a halberd spudger or the tip of an opening pick into the gap you've created. |
| + | [* icon_caution] Don't insert the pick more than 2 mm. Going any farther could permanently damage the display assembly. If using a halberd spudger, slice with the shortest part of the blade. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0