crwdns2933803:06crwdne2933803:0
crwdns2933797:0Justin Ogiharacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Ogihara
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Remove 2 screws from openings on each side of the air filter on the topside of the projector. This is done using a Phillips #1 (PH1) screw bit and a screwdriver extender on the precision bit driver. |
|---|---|
| - | [* red] The screws are 10 mm in length. |
| - | [* orange] Remove 2 screws near the place where the white panel was removed on the topside of the projector using a Phillips #1 (PH1) screw bit on the precision bit driver. |
| - | [* orange] The screws are both 10 mm in length. |
| + | [* red] Using the Phillips #1 screwdriver, remove two 10 mm screws from the openings on each side of the air filter on the topside of the projector. |
| + | [* icon_note] You may need to use a screwdriver extender to reach the two screws. |
| + | [* orange] Using the same Phillips #1 screwdriver, remove two 10 mm screws where the white panel was removed on the topside of the projector in step 1. |