crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Turn on the heat gun and direct it to the curved edges of the phone.
-[* black] Hold the heat gun over one side until the adhesive is loosened (approximately 5 minutes).
-[* black] Wedge the opening picks between the front and back panel.
-[* black] Repeat on each side of the phone until the back panel is released.
+[* black] Turn on the heat gun to a low heat and and gently heat the curved edges on the back of the phone.
+ [* icon_caution] Be careful not to overheat or melt the plastic; heat guns can get out of hand quickly!
+[* black] Wedge the opening picks between the front and back panel and slide them around the perimeter to break the adhesive securing the back cover.
+[* black] Repeat until the back panel is fully released.