crwdns2933803:03crwdne2933803:0
crwdns2933797:0Carsten Frauenheimcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Carsten Frauenheim
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the feet | |
| - | [* black] Repeat the following procedure on all four feet: |
| - | [* black] Push the tip of an opening pick under the mouse foot adhesive where the gap in the rim is. |
| - | [* icon_note] Go slowly, and make sure the pick is underneath both the foot and its adhesive layer. It's easy to separate the foot from its adhesive. |
| - | [* black] Twist the opening pick to separate the foot from the bottom until you can grab it. |
| - | [* black] Remove the foot. |
| - | [* icon_reminder] Before installing your mouse feet, clean any residual adhesive with highly-concentrated isopropyl alcohol (over 90%) and a lint-free or microfiber cloth. |
| - | [* icon_reminder] To reuse the feet, softly tack them on a clean surface such as a [product|IF145-167-4|magnetic mat|new_window=true] or a [product|IF145-257-1|sorting tray|new_window=true]. |
| + | [* black] Push the tip of an opening pick underneath the mouse foot adhesive, into the gap in the rim. |
| + | [* icon_note] Go slowly, and make sure the pick slides underneath both the foot ***and*** its adhesive pad. These layers separate easily. |
| + | [* icon_caution] If you plan on reusing your mouse feet, be careful not to crease them or separate them from their adhesive pads. |
| + | [* black] Slide your pick under the foot to separate its adhesive until you can grab it with your fingers. |
| + | [* black] Repeat to remove the three remaining mouse feet. |
| + | [* icon_reminder] For installing new mouse feet or reusing your old ones: |
| + | [* black] Use a pair of tweezers or a spudger to remove any large chunks of leftover adhesive. Thoroughly clean the bottom of the mouse with isopropyl alcohol and a lint-free of microfiber cloth. Allow the surface to dry completely. |
| + | [* black] Peel your new mouse feet away from their adhesive liners and press them firmly into place. |