crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Justin Ogiharacrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Ogihara

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Remove all 3 orange ribbon cables on the motherboard (This is done by lifting up the black side with a spudger or fingernail to release the locking mechanism, then pulling out the ribbon).
-[* orange] Remove 3 screws on grey piece that is located at the side of the motherboard using a Phillips #1 (PH1) screw bit on the precision bit driver.
- [* orange] The 3 screw measure 10 mm in length each.
+[* red] Using a spudger or your fingernails, lift up the black locking tabs and disconnect the three ribbon cables from the motherboard.
+ [* icon_note] For more information on Zero Insertion Force (ZIF) connectors, please visit [guide|25629|this guide|stepid=64969].
+[* orange] Using the Phillips #1 screwdriver, remove three 10 mm screws on the grey piece that is located on the side of the motherboard.