crwdns2933803:04crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Calibrate Z Offset |
|---|---|
| + | [* black] Jog the bed up carefully using the Z-.50 and Z-.05 buttons until the nozzle grips the paper |
| + | [* black] Once the nozzle grips the paper send G92 Z0 |
| + | [* black] Lower the bed 10mm |
| + | [* black] Move the probe to bed center(same amount as step 3 but move it to the right) |
| + | [* black] Send G30 S-1. This will probe the bed and tell you the offset. Move the bed to Z10 and run G30 S-1 again. Repeat this step a couple of times. When finished move the bed to Z10. |
| + | [* black] Take the average of the Z offset readings from the console and replace your current G31 P500 X-42.45 Y0 Z## in config.g |
| + | [* black] Save and restart your printer |