crwdns2933803:04crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Wiring/Reassembly |
|---|---|
| [* black] The NF-A6x25 is a 4 wire PWM fan. Since we don't need all 4 wires cut the harness to length(12" should be enough). | |
| [* black] Crimp on some JST 2.54 connectors. | |
| [* icon_note] 4 Pin fan: Yellow is 12v and Black is Ground | |
| [* icon_note] 3 Pin fan: Red is 12v and Black is ground | |
| [* black] Mount the NF-A6x25 were the original fan was with the 2 screws that held in the Sunon fan. Make sure the airflow arrows point towards the board. | |
| [* black] Insert the board into the case and secure it with the 5 screws. | |
| [* black] Connect the NF-A6x25 fan to the board. Positive on the left and Negative on the right | |
| [* black] Slide the casing cover on and the remaining 6 screws |