crwdns2933803:07crwdne2933803:0
crwdns2933797:0Lourttan Arulananthamcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Lourttan Arulanantham
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Insert wisdom here. |
|---|---|
| + | [* black] Place the new tube of silicone in the gun, cut off about a half inch off of the tip and poke the hole with the accessory on the caulking gun. |
| + | [* black] Press slowly until glue comes out, start from one end and press as you run the silicone to the other end in one motion. Put an amount of glue that slightly comes out of the corner that your caulking. |
| + | [* black] Make sure to put enough glue and not a little, as you will need to run your finger down the glue in one motion to smooth it out. Run your finger only once. |
| + | [* black] Wait about 10 minutes and remove the tape so that the glue doesn't fully dry with the tape. Also you will get a clean finish on the ends. |