crwdns2933803:03crwdne2933803:0
crwdns2933797:0filip.kolinskycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 filip.kolinsky
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] middle part/anchor | |
| - | [* black] The lens assembly is held by twisting and by pressure from the bottom plate. Remove 4 from bottom plate. |
| + | [* black] The lens assembly is held by twisting and by pressure from the bottom plate. Remove 4 screws from bottom plate. For me these were the most stubborn and needed a bit of WD40 for them to get loose. |
| [* black] Lens should now be able to twist by about 1/8 of a turn. Take off and set aside. | |
| [* black] Clean with soapy water. Dry with towel. Any stains or residue remove with appropriate chemicals. | |
| [* black] After is everything cleaned and dry reassemble. | |
| [* black] If you live in very humid environment or at sea, it might be good to apply some kind of protective paint to the inside of this assembly to prevent rusting. But the choice is yours. |