crwdns2933805:0crwdne2933805:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] PID Tuning Your Hot End For The First Time |
|---|---|
| + | [* black] Sometimes PID tuning can fail if using the stock firmware settings. I like to PID tune each heater independently, than re-tune with the other heater at print temp. |
| + | [* black] Move the nozzle to the center of the bed. I generally have the nozzle about 3mm from the bed surface. |
| + | [* black] With the hot end at room temperature run M303 H1 P1 S200 |
| + | [* black] This will PID tune Heater 1(hot end) to 200c at full power(P1) |
| + | [* black] When it's finished replace the M307 string found in the console with what's in your config.g |