crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Samcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Peen over shaft end so that it holds down head and assembly
[* icon_note] This step may require two people - one two hold the assembly and the other to peen the threaded shaft end over.
-[* black] Make sure to hold the assembly down against a surface that is in contact with the metal shaft underneath (we used a 3mm rod clamped in a vice). This will provide much better support than clamping it into a vice which will damage the plastic bottom.
+[* black] Make sure to rest the assembly down against a surface that is in contact with the metal shaft underneath (we used a 3mm rod clamped in a vice).
[* black] Next peen over the 1mm exposed end of the threaded shaft so that it holds the head down (and rest of assembly).