crwdns2933803:09crwdne2933803:0
crwdns2933797:0Renshcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Rensh
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Start reassembling in the new case |
|---|---|
| + | [* black] Now you have to put all the components back in the new case, to do that please refer to the following steps |
| + | [* orange] Replace the proximity sensor and the blue plastic piece back in the new case, first remove any protective film that may be present |
| + | [* blue] Now peel off any eventual protective film, one may be placed on a copper heater sink |
| + | [* red] Now you have to apply a new thermal paste on the heat sink as in picture |
| + | [* icon_note] Please use very little amount of paste for this operation |
| + | [* black] Then you can place back the motherboard and gently push it in place with your fingers until you find it very firm in its position |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0