crwdns2933803:02crwdne2933803:0
crwdns2933797:0justin boydcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 justin boyd
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] In order to replace the small LED light at the front of the device simply go to the front section of the drill and look below the motor and transmission to find a black plastic piece with two very skinny wires emanating from it. |
|---|---|
| + | [* black] With the drill laying flat to the ground and the components facing directly up, pull the black plastic piece straight up towards the ceiling and out of the orange plastic drill body that it fits neatly inside, make sure to take note of how these two pieces fit together as you will be putting them back together at the end. |
| + | [* black] The small wires will still hold the black housing attached to the circuit board on the power switch so be careful to not pull to hard or far out. |