crwdns2933803:01crwdne2933803:0
crwdns2933797:0Philip Le Richecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Philip Le Riche
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Remove two screws holding the buttons board to the midframe. | |
| [* black] Lift the buttons board from the power button end, and release the other end from beneath a retaining tab. | |
| [* icon_note] On reassembly, ensure that the right hand end of the buttons board is correctly located under the tab, otherwise the assembly will not fit back in the case. | |
| [* black] If required, you can now unsolder and replace any of the buttons. For this, a desoldering pump is most effective. | |
| - | [* icon_note] Replacement 6x6mm tactile buttons are widely available in a range of heights. The 5mm height should fit, but lay a ruler along the tops of all the buttons to check the height |
| + | [* icon_note] Replacement 6x6mm tactile buttons are widely available in a range of heights. The 5mm height should fit, but lay a ruler along the tops of all the buttons to check the height before soldering a replacement. |