crwdns2933803:02crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Extruder Gear |
|---|---|
| + | [* black] Insert the large gear into the back housing so the teeth mesh with the stepper gear teeth. |
| + | [* black] Move the stepper gear down towards the stepper until the teeth mesh. |
| + | [* black] This can be a bit of trial and error. Make sure the large gear is straight. When you move the large gear left or right the stepper gear should move the opposite way with no backlash. |
| + | [* black] Tighten the set screw on the stepper gear. The stepper gear should be about 3mm from the end of the shaft |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0