crwdns2933803:01crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Extruder Gear | |
| - | [* |
| + | [* icon_note] I've found mounting the stepper gear to the stepper shaft can be the most difficult part. |
| [* red] Start by sliding the stepper gear on the stepper shaft so the set screw is on the flat side of shaft. | |
| - | [* black] Start by mounting the extruder mount to the frame with 2x M5x10 button head screws and 2x M5 T-nuts. Placement isn't an issue because this is only for putting the gear on the stepper shaft |
| - | [* black] Place the E stepper motor in the mount. |
| - | [* black] Disassemble the BMG extruder and place the back half on the extruder mount. Make sure the orientation is correct. |
| + | [* black] Mount the extruder mount to the frame with 2x M5x10 button head screws and 2x M5 T-nuts. Placement isn't an issue because this is only for putting the gear on the stepper shaft |
| + | [* black] Disassemble the BMG extruder and place the back half on the extruder mount. Make sure the orientation is correct. Place the E stepper motor in the mount. |
| [* black] Using 2x M3x20 socket head screws and 1x M3x30 socket head screw mount the back half and the stepper to the mount. |