crwdns2933803:06crwdne2933803:0
crwdns2933797:0Wayne Robertscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Wayne Roberts
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Removing the Vibration Motors And Screws From the Motherboard | |
| [* black] The wires will need to be desoldered from the board, and will be replaced later for reassembly. | |
| [* black] Note: each pair of wires has the black cable soldered to the lower connection; keep this in mind for the reassembly if the pictures from this guide aren't nearby. | |
| + | [* black] Some of the solder in this controller requires a very high temperature to release. I had mine set to 450 C, however you may be able to remove it at a lower temperature. |
| [* black] Remove the two T-6 screws from the board near the vibration motors. |