crwdns2933803:013crwdne2933803:0
crwdns2933797:0Mattcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Matt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove hard drive |
|---|---|
| + | [* orange] Remove the 2 black 3.5mm phillips screws from the bottom side of the board. |
| + | [* icon_caution] The hard disk will only be connected by the IDE connector. Support the hard drive with your hand while turning the board over. |
| + | [* green] Gently, but firmly remove the hard drive from the IDE connector by wiggling back and forth slightly and pulling back toward the side of the board. |
| + | [* icon_caution] If you have made it this far, DO NOT STOP HERE. It's virtually impossible to re-seat the system board correctly without disassembling further. Proceed to the next step! |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0