crwdns2933803:09crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] LEDs | |
| - | [* |
| + | [* icon_note] I used different LEDs than what were in the kit but they are installed in the exact same way. |
| [* black] The wiring is pretty straight forward. The important thing to remember is with the Wago connectors one side is input and the other side is output. Make sure you do not cross the polarity | |
| [* black] The Black wire on the push button latching switching goes to the Negative - terminal on the PSU output | |
| [* black] The Yellow wire on the push button latching switch goes to the positive + side of the PSU output. | |
| [* black] The Green and Red wire on the push button latching switch goes into one of the contacts on the Wago connector. This will be the Positive + side | |
| [* black] The single Black wire in the kit goes from the Negative terminal on the output side of the PSU to the open contact on the same side as the Green/Red wire. | |
| [* black] The both Red Positive + wires of the LEDs will go in the opposite side of the Green/Red wires | |
| [* black] Both Black Negative - wires of the LEDs will go in the opposite side of the Black Negative - wire |