crwdns2933803:07crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] BLV NeoPixel Board | |
| [* black] Connect the white/black wire from the NeoPixel board to the PanelDue port on the Duet | |
| [* black] Connect the +/- from the NeoPixel board to the PSU output. Make sure you pay attention to polarity. | |
| [* black] Connect the 3x 3 wire NeoPixel rings to the NeoPixel board | |
| - | [* black] |
| + | [* black] I didn't like the long 2 wire cable going back to the Duet. A simple modification you can do if you have the ability to crimp new connectors is you can connect the BLV NeoPixel board to the side of the PanelDue |
| [* black] Connect the White(RX) wire from the BLV NeoPixel board to the TX porton the PanelDue. | |
| [* black] Connect the Black(GND) wire from the BLV NeoPixel Board to the GND port on the PanelDue |