crwdns2933803:02crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Bottom Panel | |
| [* black] Remove the protective film from both sides of the panel. | |
| - | [* black] Take 4x 10mm brass standoffs and secure them to the underside of the front half of the bottom panel with 4x M3x6 |
| + | [* black] Take 4x 10mm brass standoffs and secure them to the underside of the front half of the bottom panel with 4x M3x6 button head screws.(opposite side of the countersunk holes) |
| [* black] Mount the BLV NeoPixel board to the front half of the bottom panel with the reset button facing the cutouts for the wires(towards the front of the printer) | |
| [* black] Connect the black/white 2 wire cable to the transmission port. Connect the red/black power wires to the power input. | |
| [* black] Screw on 12x M3x8 countersunk screws and 12x M3 T-nuts onto the front and back half of the bottom panel. | |
| [* black] Drop the 2 halves of the bottom panel into the frame with the T-nuts dropping into the channel. | |
| [* black] Once you have equal spacing tighten the M3x8 countersunk screws |