crwdns2933803:013crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Belt Locker | |
| [* black] When we pull the belts tight to lock them in place we want a little counter tension on the tensioners. Tighten the tensioner knob a few turns until the tensioner looks similar to this. | |
| - | [* |
| + | [* icon_caution] It is not advised to use the belt lockers that come in the metal kit. They are beta parts but the preferred way is zip-ties |
| [* black] Pull the belts through the front plate so they're tight. I used a few drops of superglue on the smooth side of the belt. | |
| - | [* |
| + | [* icon_note] I clamped the belt to the 2020 to give the glue time to dry. |
| [* black] Remove the clamps after 5 minutes. Tighten the zip-ties and cut off the tail and the extra belt length. |