crwdns2933803:01crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Belts Rear Plate | |
| [* black] You should have 1 long belt. Start by cutting it in half. It doesn't have to be exactly in half because you will have extra belt length when finished. | |
| [* black] Feed the belts through the belt guides on the rear plate. When the rear plate is installed the belt teeth fill be towards the X 2020 extrusion. | |
| - | [* black] For added security I like to use a few drops of superglue(I use Loctite Gel). Fold the belt over so the teeth interlock. Using a pair of needle nose pliers to hold the belts for about a minute to give the glue time to set. |
| + | [* black] For added security I like to use a few drops of superglue(I use Loctite Gel). Fold the belt over so the teeth interlock. The belt only needs to overlap no more than about 1 inch. Using a pair of needle nose pliers to hold the belts for about a minute to give the glue time to set. |