crwdns2933803:03crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Loosen the 3x M3x12 screws enough so the top plate can move. |
|---|---|
| + | [* black] Slide the stepper mount assembly on to the frame so the T-nuts slide into the channels on the extrusion. When tightening the M5x8 screws keep pressure on the bottom of the mount so when tight it will sit flush with the bottom of the 2040 |
| + | [* black] Pressing the top plate mount towards the frame make sure the sides of the top plate are flush with the bottom |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0