crwdns2933423:0crwdne2933423:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Dylancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dylan

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[title] Baring cables and terminating wires
+[* black] I’m this step, bare the flex back around three to four inches, for this you can use a sharp knife to very lightly slice around the flex being very careful to to cut the cores inside. If you score it well you will be able to manipulate the cable by bending it back and fourth and it will snap the insulation along the line you have cut with the knife.
+[* black] please be very careful not to cut yourself or others while doing this. If you have cut into or damaged the inner cores in anyway cut it off and start again. When you have removed the outer insulation you will have two cores (a brown and a blue). Bare both the cores back around 8mm.
+[* black] you should now look at the crimp you are going to use and decide whether or not there is space for the wire to be doubled over, doing this will insure the cable has a tight and secure connection.

crwdns2933777:01crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:02crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:03crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0