crwdns2933803:09crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Right Corner | |
| [* black] Thread in the M3x30 with bearings on it into the top plate to prevent the bearing from falling out. | |
| [* black] Position the bottom plate so 4x M5x8 button head screws so the T-nuts will drop into the channel. Do not tighten completely. | |
| [* red] Using a M3x6 socket head screw attach the bottom plate to the stepper but do not tighten. | |
| [* orange] Insert 2 bearing sandwiches (bearing+washer+bearing) with the bearing tool into the assembly and thread in 2x M3x30 socket head screws | |
| - | [* black] Insert 1x |
| + | [* black] Insert 1x 19mm standoff spacer and thread in a m3x30mm socket head screw. Do not tighten |
| [* black] Tighten the 4x stepper screws. | |
| [* black] Tighten the bearing screws. 2x on top and 1x on the bottom. Tighten the standoff spacer screw | |
| [* black] Tighten the 4x M5x8mm button head screws on the bottom plate |