crwdns2933803:07crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Right Corner | |
| [* black] In a CoreXY setup both X and Y stepper move together. Technically the top left stepper is the X and the top right stepper is the Y | |
| [* black] The right corner is assembled in virtually the same manner as the left. However I tried doing it in the same manner as the videos posted on the project page | |
| [* black] Note the orientation of the timing gear on the stepper shaft | |
| [* black] Attach the top plate to the frame with 2x M6x10mm black button head screws, 6x M5 T-nuts and 6x M5x8mm button head screws. Tighten the screws completely. | |
| - | [* black] Insert 3x M3x25mm |
| + | [* black] Insert 3x M3x25mm socket head screws into the stepper mounts. Slide 3x 19mm standoffs over the screws than thread the M3x25mm into the stepper motor but do not tighten. |
| [* black] The plug on the stepper motor should be facing towards the X motor |