crwdns2933803:01crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Left Corner | |
| [* black] In a CoreXY setup both X and Y stepper move together. Technically the top left stepper is the X and the top right stepper is the Y | |
| [* black] Start with taking your X motor and slide the timing gear on to the stepper shaft making sure the set/grub screw when tightened will be on the flat side of the stepper shaft. | |
| [* black] Note the timing gear orientation. We will need to make height adjustments after the belts are on | |
| [* black] Tighten the grub screw | |
| - | [* black] Slide in 3 M3x35mm |
| + | [* black] Slide in 3 M3x35mm socket head screws and 3x 29.2mm motor standoffs. Note the front stepper mounting hole that is too large for a M3 |
| [* black] Thread in the 3x M3x35mm screws into the stepper but not tight. Note the orientation of the stepper. I noticed this after I assembled this part but the wire plug should towards the middle of the printer. I had to rotate it 90 clockwise from the picture |