crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:09crwdne2933803:0

crwdns2933797:0Zachary Crawfordcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Zachary Crawford

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] To disassemble the frame,unscrew all the bolts on the frame using 10 mm wrench.
[* black] separate the handle frame pieces from the metal side structure
[* black] Please note the 4 bolts with a rubber cap on them go at the top of the wheelchair were the pushing bar is.
[* black] The fifth bolt with the rubber cap attaches the air pump containment clamp that is attached to the center support on the bottom
-[* black] Please also note that the metal support beams with diamond holes are the ones for connecting the side structure of the chair, while the metal support beam with the circular holes are used to attach the two metal hand structure, creating the cross section on which you push.
+[* icon_note] The metal support beams with diamond holes are the ones for connecting the side structure of the chair, while the metal support beam with the circular holes are used to attach the two metal hand structure, creating the cross section on which you push.