crwdns2933803:09crwdne2933803:0
crwdns2933797:0David Husolocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Husolo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Frame Assembly - Z Linear rails |
|---|---|
| + | [* black] The following steps are the same for both the left and the right side |
| + | [* black] Take 1 400mm linear rail. Insert 15x M3x8 socket head screws into the holes. Do not put a screw in the top hole(red circle) |
| + | [* black] Thread 15x M3 T-nuts onto the M3x8 screws enough so they won't fall off. |
| + | [* black] Align the linear rail so the T-nuts drop into the channel on the 20mm face of the 442mm 2040. |
| + | [* black] The top of the linear rail should be flush with the face of the 496mm 2040. Using 2 2020 linear rail guides, start at the top and work your way down the linear rail tightening the M3 screws so they're snug |
| + | [* black] Once all M3x8 screws are snug go back and tighten them 1/4-1/2 turn to tighten them completely. |
| + | [* black] Once again be mindful of the MGN carriage. You don't want the carriage to slide off the rail during assembly |
| + | [* black] To secure the MGN carriage you can wrap masking tape around the MGN carriage and the frame |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0