crwdns2933423:0crwdne2933423:0

crwdns2933803:011crwdne2933803:0

crwdns2933797:0Sean - Lua Techcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Erik Eriksson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Put the home button down 1st then put down the metal bracket give it some test clicks
+[* black] Place the home button down first, then place the metal bracket. Give the button some test clicks to insure it is mounted correctly and stable.
[* blue] Prepare for testing, by reconnecting the home button and glass digitizer's ribbon cables in the same way they were disconnected in step 7.
[* black] Remove the plastic pick from the battery connector and replace the PH000 screw.
[* black] Replace the display cable bracket with its 3 PH000 screws.
[* icon_caution] Make sure you clean the edges before continuing. A Q-Tip with a very small amount of isopropanol can assist in this. Any debris in the digitizer groove can cause the digitizer to crack.
[* black] Remount the LCD using its 4 PH000 screws into the iPad housing.