crwdns2933423:0crwdne2933423:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Arthur Shicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Arthur Shi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Remove the magnetic sensor cable
[* black] When the solder on the solder pads is melted, use a pair of tweezers to separate the magnetic sensor from the display assembly.
- [* icon_note] If the solder isn't melted, apply ten more seconds of hot air. Repeat this process as needed.
+ [* icon_note] If the solder isn't melted, apply more heat and try again.
[* black] When the area is cool enough to touch, remove the polyimide tape.
[* black] Use a pair of tweezers to remove the magnetic sensor cable.
[* icon_caution] The magnetic sensor cable is secured to the display assembly with light adhesive. Remove the magenetic sensor cable slowly to avoid damaging the cable under it.
[* icon_reminder] During reassembly, apply a piece of polyimide tape under the solder pads while soldering the magnetic sensor to avoid damaging the screen.