crwdns2933803:05crwdne2933803:0
crwdns2933797:0Kyle Smithcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kyle Smith
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the magnetic sensor cable |
|---|---|
| + | [* black] When the solder on the solder pads is melted, use a pair of tweezers to separate the magnetic sensor from the display assembly. |
| + | [* icon_note] If the solder isn't melted, apply ten more seconds of hot air. Repeat this process as needed. |
| + | [* black] When the area is cool enough to touch, remove the polyimide tape. |
| + | [* black] Use a pair of tweezers to remove the magnetic sensor cable. |
| + | [* icon_caution] The magnetic sensor cable is secured to the display assembly with light adhesive. Remove the magenetic sensor cable slowly to avoid damaging the cable under it. |
| + | [* icon_reminder] During reassembly, apply a piece of polyimide tape under the solder pads while soldering the magnetic sensor to avoid damaging the screen. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0