crwdns2933803:013crwdne2933803:0
crwdns2933797:0Gina Kittlesoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gina Kittleson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Fit the boards into the node box | |
| [* red] Slide the open storm board into the node box on the right pushed up as close to the ports as possible. | |
| [* orange] Slide the 3-4V battery into the enclosure on the left side. | |
| [* yellow] Carefully fold the connected relay board over so that it fits within the enclosure snuggly. | |
| [* green] Check to make sure that the connections remained secure. | |
| - | [* light_blue] Plug the 6 pin connector into the port on the open storm board. |
| + | [* light_blue] Plug the 6 pin connector into the port on the open storm board that is the second from the left side of the board in the image near the SD card port. |
| [* violet] Check that the battery port is exposed for deployment, but do not plug in the battery until the sampler is ready to begin sampling. |