crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Bryan Cervantescrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bryan Cervantes

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] This step can be tricky so get your bearings by locating the two clips holding the top and bottom cover together. They are at the center of the backside of the device.
-[* orange] Insert the flat end of a spudger horizontally between the back speaker and the back cover as seen in the second picture. Which clip you remove first is up to you.
+[* red] Locate the two plastic clips holding the bottom and back cover together.
+[* orange] Which clip you remove first is up to you. Rotate the device 90 degrees either left or right. Insert the flat end of a spudger horizontally between the back speaker and the back cover.
[* yellow] Place the flat end of the spudger behind one clip and pry it open. This may take repeated attempts.
-[* icon_note] Working at this angle can be awkward and the visibility is poor. Have someone help you with lighting and holding the device if possible. This is the hardest step so, should you get frustrated, try the other clip or take a short break.
-[* icon_note] Once a clip has been removed, hold the bottom cover open so the clip will not fall back into place. One clip remains to be removed; you are almost there.
+[* icon_note] This is the hardest step because the angle is awkward and the visibility is poor. If possible, have someone hold the device or provide lighting.
+[* icon_note] Once a clip has been removed, hold the bottom cover open so the clip will not fall back into place. One clip remains to be removed; you are almost there!